How To Use The Unit - Mitsubishi Electric T-SB116EH-W-CA Instruction Manual

Hand dryer
Table of Contents

Advertisement

How to use the unit

Power controll section
H e a t e r
O N
O F F
e d
A ir s p e
Cover
P o w e r
O N
O F F
With the power switch OFF
Power
Heater
Check
Power lamp
Heater lamp
In case of trouble or error
Power
Heater
Check
Power lamp
Heater lamp
1
With both hands open, insert them
all the way
The unit will come on automatically.
Information
As the hand dryer is open at both sides
of the main unit, your hands may also be
inserted from the sides. If your hands are
inserted from the sides and pulled
upwards a few times, you can dry your
hands without any risk of water drops
blowing upwards.
4
Heater
switch
Air
speed
knob
Power
switch
Power lamp
Display
Heater lamp
Emblem
When not using the unit for long periods of time
Turn the power switch off.
The unit consumes approximately 2W of power even if unused when the power is on.
(With the heater switch "OFF")
* When the heater switch is turned "ON", approx. 1,100 W of power is
Check lamp
consumed to accumulate heat by operating the heater.
Check lamp
When a malfunction or error occurs, the check lamp on the right side of the display will
either light up or flash. Turn the power switch off, wait approximately 40 seconds until the
all the lamps in the display go off, and then turn the power back on. If the check lamp is
still on or flashing, turn off the power, shut off the ground-fault circuit interrupter, and
Check lamp
contact your dealer.
in.
Introduction
1.
Open the power controll section cover.
2.
Turn on the power switch.
Power lamp and heater lamp turn on. (Display)
Emblem lamp turns on.
Illumination lamp turns on.
Adjust the Air speed knob to the best point.
Note:
When the power switch is turned on, make sure to remove
hands from the hand-drying area. Take sufficient care to
avoid this because it may deteriorate the sensitivity of sensor.
3.Close the power controll section cover.
Display
Check lamp
With the heater switch ON
Power lamp
2
Pull them out slowly,
letting the air blow the
water off.
Repeat until dry
How to dry your hands
1
Insert from each side.
Power
Heater
Check
Check lamp
Power lamp
Heater lamp
3
Pull hands all the way
out.
2
Bring upwards slowly.
With the heater switch OFF
Power
Heater
Check
Check lamp
Heater lamp
3
Pull out.

Advertisement

Table of Contents
loading

Table of Contents