Mitsubishi Electric T-SB116EH-W-CA Instruction Manual

Hand dryer

Advertisement

Quick Links

Hand Dryer
Model
JT-SB116EH-W-CA
Instruction Manual
You should not attempt to install the unit yourself, as this may affect the safety and functionality of the unit.
Read this manual thoroughly before beginning using the unit to ensure it is used safely and correctly.
After reading the manual, store it in a location easily accessible for later reference.
Safety precautions
WARNING
Do not install the unit yourself.
This may affect the safety and functionality of the unit.
Do not use at locations where salt damage may occur or where corrosive, neutral or reductive gases are
present.
Prohibited
Failure to do any of the above may cause fire, electric shock or trouble.
Do not use in shower room or other locations with a great deal of humidity in the air or where
condensation may form on the unit.
This may cause electric shock or malfunction.
Do not use in shower room
Do not allow water to get on unit.
This may cause electric shock.
Do not allow the unit to get wet
Do not modify or disassemble.
This may cause fire, electric shock, or injury.
When changing the installation place, consult your dealer or instraller.
Do not disassemble
There is risk of injury.
Turn off the switch before cleaning the unit.
Not doing so may cause electric shock.
This appliance is not intended for use by young children or infirm persons unless they are adequately
Important!
supervised by a responsible person to ensure that they can use the appliance safely.
Follow instructions
Young children should be supervised to ensure that they do not play with the appliance.
CAUTION
Care must be taken not to touch the heater exterior with hand or foot.
Heater exterior becomes extremely hot during operation. Touching it may cause burn on hand or foot.
Hot
Do not let children hang from the unit.
This may cause the unit to fall.
Do not use for purposes other than drying hands.
Using the unit improperly can cause accidents.
Prohibited
Always use the unit with the drain tank and air filter attached.
Any water entering the unit may cause short circuits and electric shock.
Wear gloves when cleaning the unit.
Not doing so may cause injury.
If the unit stops working or begins acting strangely, turn off the power switch and ground-fault circuit
interrupter and contact your dealer for inspection and repairs.
Important!
Failure to do any of the above may cause electric shock or fire through short circuit.
Follow instructions
Wait till the heater exterior cools down before starting maintenance.
Otherwise, it could cause burn.
Make sure to install the air filter on the heater and close the panel before starting to use.
Unless the filter is installed or panel is closed, dust entering the unit may cause fire.
The following may lead to death or serious personal injury if done incorrectly.
The following may lead to injury or damage to buildings or their contents if done incorrectly
0612874HD6901
GB
Single-phase 120VAC
For User

Advertisement

Table of Contents
loading

Summary of Contents for Mitsubishi Electric T-SB116EH-W-CA

  • Page 1 0612874HD6901 Hand Dryer Model Single-phase 120VAC JT-SB116EH-W-CA For User Instruction Manual You should not attempt to install the unit yourself, as this may affect the safety and functionality of the unit. Read this manual thoroughly before beginning using the unit to ensure it is used safely and correctly. After reading the manual, store it in a location easily accessible for later reference.
  • Page 2: Safety Precautions

    Safety precautions (Continued) Note Do not use in the following locations: ● Locations where the temperature could be lower than 0˚C or higher than 40°C. ● Locations where the humidity could be lower than 5% RH or higher than 95%RH. ●...
  • Page 3: Names And Uses Of Parts

    Names and Uses of Parts Power controll section Heater switch H e a t e r O F F speed A ir s p e knob Cover P o w e r Power O F F switch Power lamp Display Emblem Heater lamp Check lamp...
  • Page 4: How To Use The Unit

    How to use the unit Power controll section Heater Introduction switch Open the power controll section cover. H e a t e r Turn on the power switch. O F F speed Power lamp and heater lamp turn on. (Display) A ir s p e knob Emblem lamp turns on.
  • Page 5: Maintenance

    Maintenance Maintenance and cleaning of the exterior Before the unit starts looking too dirty Warning Caution Always turn off the power when Wear gloves when cleaning. cleaning the unit. Wait till the heater exterior cools down before starting maintenance. (It may cause burn.) Do not splash water on the unit.
  • Page 6 Maintenance (Continued) Cleaning of the hand drying area (Cleaning of the black wall area) About once every week Black wall area ● Sensor’s sensitivity may be reduced if the black wall area is fouled in white. Clean the area at least once a week according to the Maintenance and cleaning of the exteriors.
  • Page 7 Maintenance (Continued) Cleaning the air filter Around once a week Filter cover 1. Open the filter cover. ● Pull the knob. 2. Remove the air filter knob 1. Clean the filter. ● Pat it lightly by hand or use a vacuum cleaner. ●...
  • Page 8: If You Think Something Has Gone Wrong

    If you think something has gone wrong? Perform the following checks and fixes. Problem Check Are any lamps in the display on? Turn the ground-fault circuit interrupter on. Has a blackout occurred? Turn the power switch on. Are you putting your hands in all the way? Place hands all the way in.

Table of Contents