Emergency Stop Light - Midland BTNEXT PRO Instruction Manual

Enabling/disabling the wired input
If needed the wired input can be enabled or disabled:
Enabling/Disabling: Make a Long press (3 sec.) on the "Forward" and "Middle" buttons
(you will hear one audio beep tone for enabling confirmation and two audio beep tones
for disabling). This setting is rembered also after turning On/Off the unit.
Wired audio in background
The audio from the wired connection can be in background to your Intercom or Phone
communication. By default this option is ON. Please refer to the paragraph "Wired
connection always in background" below to disable it.
Note that is not possible to have the wired audio source in background to the FM radio.

Emergency Stop light

On the back of your BTX1 PRO mounting kit you have an ultra bright
LED emergency stop light. Every time you make a full brake, the stop
light will turn ON to give an extra alert to the drivers behind you. In case
you need to turn it OFF temporarily (for example when you ride with a
passenger), just press long "Backward" and "Forward" button together
while in "Phone" or "Intercom" mode (a voice announcement will con-
firm the status). The unit will remember the last setting used, that mean
you need to turn ON manually the stop light pressing again "Backward"
and "Forward" button togheter.
Attention: By default the stop light is OFF
Setup and special configurations
Resetting all paired devices
Sometimes you may find it necessary to delete all the pairing references stored in the
Midland BTNEXT PRO unit (reset operation).
To perform this operation you must first enter the setup mode:
› Turn off the unit
› Press and hold down the "Middle" button about 7 sec., until the Red light is on per-
manently.
› Then simultaneously press and hold down the "Volume +" and "Volume –" buttons
www.midlandeurope.com
for 3 seconds. The Blue Light will be lit on for 1 sec and then back to steady RED.
› Double click on the "Middle" button to exit the "Setup" mode and use the Midland
BTNEXT PRO.
This procedure deletes all the paired Bluetooth devices stored in the memory and it is
therefore possible to start a new "clean" pairing session.
Attention: after resetting all the pairting, only the "FM Radio" mode wil be available.
Back to factory setting
Sometimes you may find it necessary to go back to the factory setting, to reset all the
changes/setup already made and have a "clean" unit.
To perform this operation you must first enter the setup mode:
› Turn off the unit
› Press and hold down the "Middle" button about 7 sec., until the Red light is on per-
manently.
› Then simultaneously press and hold down all the three buttons "Forward"-"Midd-
le"-"Backward" for 3 seconds. The Blue Light will be lit on for 1 sec and than back to
steady RED.
› Double click on the "Middle" button to exit the "Setup" mode and use the Midland
BTNEXT PRO
Adjusting/ Disabling the VOX feature (Intercom and telephone)
The Intercom feature can be enabled both manually and vocally (VOX). The VOX acti-
Stop Light
vation is influenced by the helmet type, the background noise and therefore by the
speed.
For optimum results, it is possible to choose one of the following four microphone sen-
sitivity levels: high, medium, low and very low. It is also possible to disable the VOX
feature in order to activate the Intercom and phone call answering features in manual
mode only.
Adjusting the sensitivity of the (VOX)
To perform this operation you must first enter the setup mode:
1. Turn off the unit
2. Press and hold down the "Middle" button about 7 sec., until the Red light is on per-
manently.
3. Your Midland BTNEXT PRO is now in "Set up mode".
33