Light And Sound Signals/Unit Functions; Unit Functions - Midland BT2 Owner's Manual

LIGHT AND SOUND SIGNALS
LED indication
GENERAL
None
Single Blue flash every 3 seconds
Triple red flash
Single Blue flash every 3 seconds
Single Red flash every 3 seconds
RED and BLUE (together) every 3
seconds
RED and BLUE (together) and one flash
of RED light every 3 seconds
Single red flash every 2 seconds
SETUP
Steady Red
Rapid Red-Blue alternating flash
Steady Blue for two second
Blue light two time long flash
Audio signals
Ascending tone (low-high)
Descending tone (high-low)
Enable/Disable the Intercom
1 tone
2 tones

UNIT FUNCTIONS

If you want to...
GENERAL
Turn on the unit
Turn off the unit
Increase the volume
16
Status
Unit is switched off or full charged when connected to the power supply
Unit being turned on
Unit being turned off
Standby
Standby - low battery
Active (Intercom, phone call or Bluetooth connection in progress)
Active but low battery
Unit in charge when connected to the power supply
Setup mode
Pairing mode (searching for devices)
Successful pairing/ Reset paired devices/Three way enabled
Three way disabled
Status
Unit being turned on
Unit being turned off
1 tone = enabled / 2 tones = disabled
Specific feature turned on
Specific feature turned off
...do this
Press the Intercom button for 3 seconds at least (start Blue flash)
Press the Intercom and AUX button together for 3 seconds (triple Red flash)
Short or continues press on the Volume Up control