Midland BTX2 PRO Instruction Manual page 25

The Midland BTX2 PRO has three main buttons (Forward, Middle and Rear). It is up to
you which button use to pair and activate the "Intercom", you are totally free to choose
the button you like more.
Rider 1
Rider 3
Passenger
The same button you will use to pair the unit will be also used to open/close the intercom
communication. For example you can pair your passenger to the Middle button and other
motorbikers to the Backward and Forward button. Everytime you open the "Intercom"
connection to one person, the previous connection will be closed.
The connection is not a "chain", when two persons are talking it is not possible to break
(interrupt) the communication by one of the other units.
Pair the Midland BTX2 PRO to another Midland BTX2 PRO unit
To pair the Midland BTX2 PRO to another Midland BTX2 PRO unit, you must first enter
the setup mode:
1. Turn off the unit
2. Press and hold down the middle button about 7 sec., until the Red light is on permanently.
3. Now press the Middle or the Backward or the Forward button for 3 seconds. The Blue and
Red lights will flash.
4. Do the same procedure on the other unit, when successfully paired, each unit will have the
Blue light on for one second and then go back to the setup mode (Red light always on).
5. Now the pairing procedure is complete, you can go on pairing other units on different but-
ton or just exit the setup mode to start using the units:
Double click on the Middle button, the Red light will turn off and the Blue light will start
flashing.
You can use now your BTX2PRO.
www.midlandeurope.com
How to use the Intercom with more than two units
To use the intercom feature, be sure that all the units are turned on and correctly paired
together.
Manual activation in Intercom mode
Press the button corresponding to the unit you would like to communicate with. After some
seconds the intercom communication will open.
The communication remains active until you press again the same button. To quickly open
the intercom to another person, just press the button corresponding to the other unit, the
intercom will be automatically closed and the new connection will be opened.
Rider 2
Voice activation (VOX)
The voice activation feature can open the intercom only to the unit paired to the Middle
button. While no other communication is open, simply start talking and the commu-
nication will be opened and remain active for all the time you are talking. If there is no
conversation the intercom will be closed after 40 seconds. If needed you can close the
intercom manually without waiting 40 seconds, pressing the Middle button.
If needed, you can disable the VOX feature simply by pressing the Backward button for
7 sec. A voice announcement will advise you when the VOX is disabled. To turn the VOX
on again, just press the same button and a voice announcement will advise you that the
VOX is now active. This setting is remembered also in you turn off the unit.
Hint: this feature is very useful when you have a specific person that you like to talk to more
often (for example your passenger). In this way you don't need to press a button to open the
communication.
Unit already busy in a conversation
If you try to open an intercom connection to another person that is already talking with
some one else (or is in a middle of a phone conversation), you will hear a "busy" double
beep tone. Just wait sometime and try again, maybe this time the "line" is not busy.
The person who is called, will be advised that someone is trying to call and will hear a voice
announcement with the number of the button from which the request is coming.
In this way as soon as the first conversation is over, the person can easily contact the
caller by opening the intercom of the specific button number (indicated by the voice
announcement).
23