Installing The Modem; Minimum System Requirements; Ethernet Port Connectivity (5100/5200 Series); Usb Port Connectivity (5200 Series) - Efficient Networks SpeedStream 5100 Series User Manual

Minimum System Requirements

At a minimum, your computer must be equipped with the following.
Ethernet Port Connectivity
•
A network adapter card (NIC) that supports Ethernet 10/100Base-T full-/half-duplex
•
Operating system that supports TCP/IP
•
Internet Explorer or Netscape versions 4.0 or later
USB Port Connectivity
If connecting to the modem via USB (SpeedStream 5200 Series), your computer must meet
manufacturer's minimum requirements and be equipped with the following:
•
32 MB RAM
•
Pentium-compatible 166 MHz processor (or faster)
•
12 MB available hard disk space

Hardware Installation

You may position the SpeedStream PPPoE modem at any convenient location in your office or home. No
special wiring or cooling requirements are needed. You should, however, comply with the safety
guidelines specified in the General Safety Guidelines.

Basic Installation Procedure

1. Install line filters if necessary.
2. Connect the cables.
3. Plug the modem into the electrical outlet; then verify port status.
4. Configure network settings
5. Install USB drivers if necessary (5200 series).
6. Configure the modem
7. Reboot the computer if prompted.

Installing Line Filters

This section may not apply to you. Consult your provider if you are unsure.
Note
Because DSL shares the telephone line, you may need to separate the two signals so they do not interfere
with each other. A line filter (not included) prevents DSL traffic from disrupting the voice signal on the
(5100/5200 series)
(5200 series)
on your computer.
via the Web-based management interface.

Installing the Modem

3
SpeedStream PPPoE Modem