What To Do If Cloning Fails - Motorola DTR600 User Manual

English
you hear a distinctive audible tone saying the
word "Clone Mode Serial".
2 Place the Source Radio in its SUC. Press and
release the (+) button.
6 When the cloning is completed, the Source Radio
audible voice will announce either "pass" (cloning is
successful) or "fail" (cloning process has failed).
7 Once the cloning process is completed,turn the
Radios off and on or, long press the PTT button to
exit the 'cloning' mode.

What To Do If Cloning Fails

The radio audible voice announces "Fail" indicating that the
cloning process has failed. In the event that the cloning
fails, perform each of the following steps before attempting
to start cloning process again:
1 Ensure that the batteries on both radios are fully
charged.
2 Check the cloning cable connection on both SUCs .
54
3 Ensure that the battery is engaged properly on the
radio.
4 Ensure that there is no debris in the charging tray or
on the radio contacts.
5 Ensure that the Target radio is turned on.
6 Ensure that the Source radio is in cloning mode.
7 Ensure that the two radios are both from the same
frequency band, same region and have the same
transmission power.
NOTICE:
This cloning cable is designed to operate only
with compatible Motorola Solutions SUC .
When ordering Cloning Cable Kit, please refer to P/N#
HKKN4028_. For more information about the accessories,
see .