ehang Falcon-B410 User Manual page 37

Renaming the Drone and Compass Calibration
Step 2: As shown in the picture, hold the drone horizon-
tally with its nose pointing away from you, spin with the
drone until the grey circle is filled with blue dots, then
the interface will automatically proceed to the next step.
drone nose
Step 3: As shown in the picture, hold the drone vertically
with its nose pointing downward to the ground, spin with
the drone until the grey circle is filled with blue dots,
then the interface will automatically proceed to the next
step.
drone nose
drone nose
drone nose
Step 4: You'll see either of the following two results after
calibration.
Result 1: "Verify successful" with a deviation value less
than 10%. Just tap "Close" to exit the calibration inter-
face.
R e s u l t 2 : " Va l i d a t i o n f a i l e d " w i t h a d e v i a t i o n v a l u e
greater than 10%. You need to tap "Recalibrate" and
repeat the aforementioned steps.
33