Generac Power Systems ATC-300+ Operation And Maintenance Manual page 29

40-400A (480/600Vac) ATC-300+ 3-Postion
Contactor Based Transfer Switch
ATC-300
Available
Source 1
Available
Source 2
Help
Engine
Lamp
Test
Test
Bypass
TDNE / TDEN
Figure 23. ATC-300+ Logic (Utility Supplying Load).
Step 6: To view the setpoints, press the <Step/Enter> pushbut-
ton and enter the Password.
Note: The factory default Password is 0300. Once all installation and
testing is complete, the Password should be changed by authorized
personnel to a unique Password for the equipment.
After entering the password, press the <Step/Enter>
pushbutton until the VIEW SETPOINTS menu appears.
Select YES. Press the <Step/Enter> pushbutton to
scroll through the setpoints (Figures 24 through 26 and
Table 6).
IB01602078E
Unit Status
Connected
Load
Connected
Step
Enter se se
Alarm
Reset
For more information visit: www.generac.com
Instruction Booklet
Effective: September 2011 Page 29