Battery Care; Recharging The Battery - Recon Mod Live User Manual

BATTERY CARE

RECHARGING THE BATTERY

4. Choose your destination (Recon Online, Facebook, Twitter etc.).
Your battery is designed to last up to three years. Follow these tips on battery care:

Never recharge the battery in temperatures below 0°C or above 40° C.

Allow enough time for MOD Live to warm up and reach ambient room temperature before
you recharge.

Never use a different AC adapter and USB cable than what was shipped with the unit.

Use DISPLAY OFF mode when you aren't checking looking at the dashboard or stats.
NOTE: Whenever the battery warning popup appears, your unit will be automatically shut down
unless you recharge it immediately. Recharge the battery immediately to avoid losing data. The
battery must be recharged within ten days.
Before You Start

Use the Recon AC adapter and USB cable included in the MOD Live box. Check that the AC cable
says Recon Instruments.

Check that the port on your PC or Mac is a USB 2.0 port (not a keyboard port).
To charge using a PC or Mac:
1. Make sure your computer is turned on, and not in stand-by mode.
2. Make sure MOD Live is turned off. If the unit is on, hold down the power button for 2 seconds.
3. Connect the USB cable shipped with MOD Live. Plug the micro USB cable's smaller end into the
micro USB port located under the protective cover on the right side of the goggles. Plug the USB
cable's larger end into the USB port in your PC or Mac.
4. Check that a red light above the USB port appears. This shows that MOD Live is charging.
Tip: If your computer does not recognize MOD Live, try reinserting the USB cable.
The red USB port light turns off when MOD Live is charged.
To charge using a power outlet:
1. Connect the USB cable shipped with MOD Live. Plug the micro USB cable's smaller end into the
micro USB port located under the protective cover on the right side of the goggles
2. Plug the USB cable's larger end into either the North American or European AC adapter shipped
with your unit.
3. Plug the AC adapter into a wall outlet.