Table of Contents
Advertisement
SETUP INSTRUCTIONS
STEP 1. GOGGLE SETUP
Only use goggles that are Recon-Ready®. 2011 Recon Ready™ partners include: Uvex®, Briko®, Zeal®, and Alpina®.
Learn more about Recon-Ready goggles at http://www.ReconReady.com
STEP 2. CHARGE UP MOD LIVE
NOTE:
Always use the Recon AC adapter and USB cable shipped with your unit. Never use third-party cables or adapters.
1)
Remove the lens from the goggle frame.
goggle manufacturer.
2)
On the frame of your goggles, remove the protective badge from the left side of
the frame. This will reveal slots for MOD Live to be inserted.
3)
Next, insert MOD Live into the goggle frame as follows: with the goggles facing
you, snap the MOD Live micro optics display unit into the left inner corner of the
frame. Next, insert the battery pack into the right corner.
4)
Push the MOD Live cable into the groove so that it fits tightly.
5)
If the cable is too short, tug it gently so the white stripes appear. If the cable is
too long, push it back in.
6)
Insert the lens back into the goggles. Take care not to touch or smudge the lens.
To fully charge MOD Live using an AC adapter:
1)
Make sure MOD Live is turned off before you start.
power button
2)
Assemble the AC adapter by inserting the North American or European plug.
3)
Insert the large plug of the USB cable into the adapter port.
See instructions provided by the
Kirill: insert an illustration that shows
Advertisement
Table of Contents
