Table of Contents
Advertisement
Why does the dashboard show a solid white bar but no speed?
While MOD Live is waiting for a GPS signal, the dashboard speedometer displays "--"until it can calculate a valid speed from GPS data.
Steps to take:
1.
Wait for a few minutes after the GPS indicator turns green.
2.
Restart MOD LIVE: turn the power off, wait a few seconds, and then turn the power on.
3.
If the problem persists, contact
Why is the speed value wrong?
MOD LIVE uses GPS technology to determine speed. GPS technology works best in open spaces with a 360 degree view of the sky. Being
in a valley, beside a tree, building or rock face can block MOD LIVE from getting GPS coverage.
Steps to take:
1.
If you have just turned on the MOD Live, wait ten minutes.
2.
Move to an open location with a clear view of the sky. If you are in a valley or gulley, move to higher ground.
3.
Check the GPS status indicator.
4.
If changing location does not help, turn the power off and on again.
5.
If you can't get a GPS signal, contact Recon Support.
Why is the altitude wrong?
MOD Live is designed for use between 0m and 8850m altitude (measured from sea level), and should be used only
MOD Live calculates altitude using a combination of air pressure and GPS data. When MOD LIVE is not moving, data from the air pressure
sensor is changed to match the GPS reading. Storms affect air pressure, causing the altitude to decrease. In clear weather, altitude data
will increase.
Steps to take:
1.
If you have been sitting or standing in an open area for more than a half hour, turn MOD LIVE off and on.
2.
Wait ten minutes.
3.
Turn MOD Live back on.
Why are my statistics wrong?
MOD Live uses GPS technology to determine statistics. Your location affects the GPS coverage, for example, being in a valley, beside a
tree, building or rock face.
Steps to take:
1.
Move to an open location with a clear view of the sky. If you are in a valley or gulley, move to higher ground.
2.
Reset statistics by navigating to the Preferences menu, choosing RESET STATS and then choosing YES at the prompt to save
and reset.
Why does the clock show the wrong time?
www.reconinstruments.com/support
for support
Advertisement
Table of Contents
