Performing A Factory Reset - Recon Mod Live User Manual

PERFORMING A FACTORY RESET

DOWNLOADING MOD LIVE DATA TO YOUR COMPUTER
Kirill: do we have an image of the
HQ prompt?
Kirill: do we have an image of a
run on a Google map?
Perform a reset if any app seems frozen, missing from the display, if you can't get a GPS fix even
after restarting. WARNING: A factory reset clears all data that MOD Live has recorded, unpairs
the remote controller, clears your settings, uninstalls any third-party apps, and restores MOD
Live back to the default settings it was shipped with.
How to perform a reset:
1. Hold down the MOD Live power button and wait until the blue power light and red battery
charging light blink.
2. When the red LED starts to flash quickly, let go of the power button.
3. Hold down the power button until both red and blue LED lights blink in unison. Let go.
4. Hold down the power button for another second.
NOTE: You need to re-pair your remote controller with MOD Live after each reset. See the
section on repair instructions.
Download MOD Live's data to Recon HQ software to preserve memory or access MOD Live data
you want to share. We recommend downloading if your battery has been draining quickly, after
five days of use, or if you have accumulated a lot of text messages.
To download data from MOD Live:
1. Turn MOD Live off by holding down the power button for 2 seconds.
2. Attach the USB cable shipped with MOD Live to your computer and to MOD. Plug the micro
USB cable's smaller end into the micro USB port located under the protective cover on the
right side of the goggles. Plug the USB cable's larger end into the USB port in your PC or Mac.
Tip: If your computer does not recognize MOD try reinserting the USB cable.
3. Click DOWNLOAD when the prompt DOWNLOAD TRIPS FROM GOGGLE appears.
On your computer, a Google satellite map appears overlaid with your recorded movements on
runs, terrain parks or into the backcountry.
IMPORTANT NOTE: To avoid losing data, never disconnect while data is being transferred
from MOD Live to your PC or Mac.
4. Press down on the plastic USB port cover on MOD Live. The seal should be snug so that water
and snow can't ruin the port.