Paxton Net2 Entry Instruction page 4

Use the up and down arrows on the panel to view all the menu options.
Initialising a new system
The first time the system is powered up the panel will request that the Engineer code is set up. Enter the required
code and press the bell key. Confirm the code and press bell to complete the process.
The Net2 Entry system uses a separate control unit to operate the door. To associate a panel with its control unit,
the Serial Number of the control unit must be entered.
Calling a Monitor unit
Single Occupancy
When only one monitor ID is in use, pressing the Bell button will call the monitor.
How an Occupant gains entry
For access control, a Net2 system is required for administration. Once set up, a user can gain entry by presenting their
token to the panel. For PIN or Code entry, the # key must be pressed first before pressing the numbers on the panel.
Using the Engineer menu
To access the Engineer menu from the default screen press *, enter the Engineer code and press the Bell button.
*
As Monitor units are added to the system, they
will automatically become active. To call a monitor
type in the monitor ID and press the Bell button.
#
X
Use the key to Cancel
Page 4