Gearbox Oil Level Check - Vetus M Series Operation Manual

6 Maintenance
Vetus engines are normally equipped with
Technodrive or ZF-Hurth gearboxes. Consult
the supplied Owners Manual for more details
about care and maintenance. In case your
engine is equipped with another brand of
gearbox follow the instructions given in the
supplied owners manual for changing oil and
other care and maintenance.
26 Oil level check
• Techno Drive, TMC40, TMC60 en TM345:
Take the dipstick out of the gearbox hous-
ing by pulling.
• Check the oil level by cleaning the dipstick
and lowering it into the hole up to the rub-
ber grommet and pulling out again.
The oil level must between the two marks
on the dipstick.
• If necessary top up by pouring oil into the
filler hole.
64
• ZF keerkoppeling: Unscrew the dipstick
out of the gearbox housing.
• Check the oil level by cleaning the dip-
stick and lowering it into the hole, without
screwing it in.
The oil level must between the end and the
mark on the dipstick.
• If necessary top up by pouring oil in the
dipstick hole.

Gearbox oil level check

Every 100 operating hours.
For oil type and specification see page 128.
• Remember to replace the dipstick.