CORDLESS FLASHLIGHT UB10DL INSTRUCTION MANUAL
Do not look at the light directly.
Do not open the front cover immediately after using the
flashlight because the bulb is very hot.
Be sure to turn the switch OFF before replacing the bulb
or when not using.
Do not expose the flashlight to rain.
Dimensions (without battery)
Weight (without battery)
HOW TO USE
1. Battery insert/removal
Insert the battery in direction A until it clicks. To remove,
extract it in direction B while holding down the latch. (Fig. 2)
2. Head angle adjustment
The angle of the head can be adjusted according to use.
The head rotates from 0° to 180° and can be fixed in 8
steps. (Fig. 3)
3. Bulb replacement
Turn the flashlight so that the lens is facing downward,
taking care not to drop the bulb, and remove the front
Témoin d'état de batterie
UC10SFL (sold separately) [Charging time : Approx. 40 min.]
BCL1015 (sold separately)
12.5 V 0.25 A
Approx. 4.5 hours (Using full charged BCL1015 battery)
2-19/64" (58 mm) (diameter) × 7-11/64" (182 mm) (length)
0.4 lbs. (170 g)
Lámpara indicadora de
Do not shock or disassemble the flashlight.
Do not allow the flashlight to contact gasoline, thinner etc.
Do not leave the flashlight in a car or the like that tends to
be exposed to be searching heat of the sun (above 60°C).
Otherwise, troubles can result.
cover, lens and reflector. After changing the bulb, replace
the front cover, lens and reflector. (Fig. 4)
4. Attach the strap as required. (Fig. 1)
If the battery indicator lamp lights when the torchilight is
turned on, the battery power is low. Replace or recharge
the battery. Failure to do so may result in the light
suddenly going off due to the over discharge protection
circuit. It is advisable to occasionally check the battery
indicator lamp status during use.