CORDLESS FLASHLIGHT UB18DAL INSTRUCTION MANUAL
Do not look at the light directly.
Do not open the front cover immediately after using the
flashlight because the bulb is very hot.
Be sure to turn the switch OFF before replacing the bulb
or when not using.
Do not expose the flashlight to rain.
Dimensions (without battery)
Weight (without battery)
HOW TO USE
1. Battery insert/removal
Insert the battery in direction A until it clicks. To remove,
extract it in direction B while holding down the latch. (Fig. 2)
2. Head angle adjustment
The angle of the head can be adjusted according to use.
The head rotates from 0° to 110° and can be fixed in 5
steps. (Fig. 3)
3. Bulb replacement
Turn the flashlight so that the lens is facing downward,
taking care not to drop the bulb, and remove the front
cover, lens and reflector. (Fig. 4)
Témoin d'état de batterie
BSL14, BSL18 Series (sold separately)
18 V 0.6 A
Approx. 4.5 hours (Using full charged BSL1430 battery)
3-23/64" (85 mm) (diameter) × 10-51/64" (274 mm) (length)
0.8 lbs. (0.35 kg)
Lámpara indicadora de
Do not shock or disassemble the flashlight.
Do not allow the flashlight to contact gasoline, thinner etc.
Do not leave the flashlight in a car or the like that tends to
be exposed to be searching heat of the sun (above 60°C).
Otherwise, troubles can result.
If the battery indicator lamp fails to light or goes off when
the torchlight is turned on, the battery power is low.
Replace or recharge the battery. Failure to do so may
result in the light suddenly going off due to the over
discharge protection circuit. It is advisable to occasionally
check the battery indicator lamp status during use.