Table of Contents
Advertisement
Quick Links
The TUSB1042EVM (EVM) is a VESA USB Type-C™ Alternate Mode redriving switch supporting data
rates up to 10 Gbps for a downstream facing port (Host). This guide describes how to bring up the EVM
and includes schematics that can be used as reference design for the alternate mode implementations of
the host system with the TUSB1042 device.
1
TUSB1042EVM
2
TUSB1042EVM Configuration
3
TUSB1042EVM Schematics
4
Bill of Materials
1
TUSB1042EVM
2
Test Board Setup
3
TUSB1042EVM Block Diagram
4
TUSB1042EVM (Schematic 1 of 4)
5
TUSB1042EVM (Schematic 2 of 4)
6
TUSB1042EVM (Schematic 3 of 4)
7
TUSB1042EVM (Schematic 4 of 4)
1
TUSB1042 Configuration Pins
2
Configuration Pin-Level Definitions
3
USB 3.1 EQ Settings
4
TUSB1042EVM Bill of Materials
Trademarks
USB Type-C is a trademark of USB Implementers Forum.
DisplayPort is a trademark of Video Electronics Standards Association.
All other trademarks are the property of their respective owners.
SLLU277 – September 2017
Submit Documentation Feedback
..............................................................................................................
.............................................................................................
...............................................................................................
...............................................................................................................
..............................................................................................................
............................................................................................................
............................................................................................
.......................................................................................
.......................................................................................
.......................................................................................
.......................................................................................
.............................................................................................
........................................................................................
........................................................................................................
...........................................................................................
Copyright © 2017, Texas Instruments Incorporated
TUSB1042 Evaluation Module
Contents
List of Figures
List of Tables
User's Guide
SLLU277 – September 2017
TUSB1042 Evaluation Module
2
2
4
9
2
2
4
5
6
7
8
2
3
3
9
1
Advertisement
Table of Contents
Related Manuals for Texas Instruments TUSB1042
Summary of Contents for Texas Instruments TUSB1042
- Page 1 10 Gbps for a downstream facing port (Host). This guide describes how to bring up the EVM and includes schematics that can be used as reference design for the alternate mode implementations of the host system with the TUSB1042 device. Contents ......................
-
Page 2: Tusb1042Evm
USB Host USB HUB/Device Figure 2. Test Board Setup The EVM comes with a legacy Type B USB receptacle to connect to USB host systems. The TUSB1042 EVM uses the Texas Instruments TPS65982 (http://www.ti.com/product/TPS65982/product) controller for power delivery and pin control. -
Page 3: Tusb1042Evm Configuration
TUSB1042EVM Configuration www.ti.com TUSB1042 EQ Control Each of the TUSB1042 receiver lanes has individual controls for receiver equalization. Table 2 Table 3 detail the gain values for each available combination for downstream, upstream and all DisplayPort™ configurations. Table 2. Configuration Pin-Level Definitions... -
Page 4: Tusb1042Evm Schematics
Receptacle VBUS_5 V 3.3 V 3.3 V 5V_IN 5 V to 3.3 V Copyright © 2017, Texas Instruments Incorporated Figure 3. TUSB1042EVM Block Diagram TUSB1042 Evaluation Module SLLU277 – September 2017 Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 5: Tusb1042Evm (Schematic 1 Of 4
R127 1K +/- 5% 20K +/- 5% SILKSCREEN 1KPU 20KPD 1KPD Copyright © 2017, Texas Instruments Incorporated Figure 4. TUSB1042EVM (Schematic 1 of 4) SLLU277 – September 2017 TUSB1042 Evaluation Module Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 6: Tusb1042Evm (Schematic 2 Of 4
CTX2P C_USB_TN C_USB_TN CRX2N CRX2N C_USB_TP C_USB_TP CRX2P CRX2P TPD4E05U06 TPD4E05U06 Copyright © 2017, Texas Instruments Incorporated Figure 5. TUSB1042EVM (Schematic 2 of 4) TUSB1042 Evaluation Module SLLU277 – September 2017 Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 7: Tusb1042Evm (Schematic 3 Of 4
PMEG3050EP, 115 I2C_SDA1021 I2C_SDA1 5V_COM R112 Pad Sharing DNI, PMEG3050EP, 115 Copyright © 2017, Texas Instruments Incorporated Figure 6. TUSB1042EVM (Schematic 3 of 4) SLLU277 – September 2017 TUSB1042 Evaluation Module Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 8: Tusb1042Evm (Schematic 4 Of 4
20V DC_OUT SHIELD4 SHIELD3 SHIELD2 SHIELD1 POWER1 SENSE POWER2 GND2 GND1 JPD1135-509-7F Copyright © 2017, Texas Instruments Incorporated Figure 7. TUSB1042EVM (Schematic 4 of 4) TUSB1042 Evaluation Module SLLU277 – September 2017 Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 9: Bill Of Materials
CONN PWR JACK 2.0X6.5MM HIGH CUR J11,J12 NC, HDR10x2 M .1 HDR_THVT_2x10_100 Sullins Connector Solutions PPPC102LFBN-RC 20 Position Header Connector 0.100" (2.54mm) Through Hole Gold Receptacle SLLU277 – September 2017 TUSB1042 Evaluation Module Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... - Page 10 NC, 100 Panasonic Electronic ERJ-2GEJ101X RES SMD 100 OHM 5% 1/10W 0402 Components R53,R56,R154 Panasonic Electronic ERJ-2GEJ103X RES SMD 10K OHM 5% 1/10W 0402 Components TUSB1042 Evaluation Module SLLU277 – September 2017 Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated...
- Page 11 PCB Label 0.650"H x Texas Instruments THT-14-423-10 Thermal Transfer Printable Labels, 0.650" W x 0.200" H - 10,000 per roll 0.200"W INT053 Printed Circuit Board. SLLU277 – September 2017 TUSB1042 Evaluation Module Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated...
- Page 12 STANDARD TERMS FOR EVALUATION MODULES Delivery: TI delivers TI evaluation boards, kits, or modules, including any accompanying demonstration software, components, and/or documentation which may be provided together or separately (collectively, an “EVM” or “EVMs”) to the User (“User”) in accordance with the terms set forth herein.
- Page 13 FCC Interference Statement for Class B EVM devices NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 14 【無線電波を送信する製品の開発キットをお使いになる際の注意事項】 開発キットの中には技術基準適合証明を受けて いないものがあります。 技術適合証明を受けていないもののご使用に際しては、電波法遵守のため、以下のいずれかの 措置を取っていただく必要がありますのでご注意ください。 1. 電波法施行規則第6条第1項第1号に基づく平成18年3月28日総務省告示第173号で定められた電波暗室等の試験設備でご使用 いただく。 2. 実験局の免許を取得後ご使用いただく。 3. 技術基準適合証明を取得後ご使用いただく。 なお、本製品は、上記の「ご使用にあたっての注意」を譲渡先、移転先に通知しない限り、譲渡、移転できないものとします。 上記を遵守頂けない場合は、電波法の罰則が適用される可能性があることをご留意ください。 日本テキサス・イ ンスツルメンツ株式会社 東京都新宿区西新宿６丁目２４番１号 西新宿三井ビル 3.3.3 Notice for EVMs for Power Line Communication: Please see http://www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page 電力線搬送波通信についての開発キットをお使いになる際の注意事項については、次のところをご覧ください。http:/ /www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page 3.4 European Union 3.4.1 For EVMs subject to EU Directive 2014/30/EU (Electromagnetic Compatibility Directive): This is a class A product intended for use in environments other than domestic environments that are connected to a low-voltage power-supply network that supplies buildings used for domestic purposes.
- Page 15 Notwithstanding the foregoing, any judgment may be enforced in any United States or foreign court, and TI may seek injunctive relief in any United States or foreign court. Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2017, Texas Instruments Incorporated...
- Page 16 IMPORTANT NOTICE FOR TI DESIGN INFORMATION AND RESOURCES Texas Instruments Incorporated (‘TI”) technical, application or other design advice, services or information, including, but not limited to, reference designs and materials relating to evaluation modules, (collectively, “TI Resources”) are intended to assist designers who are developing applications that incorporate TI products;...
-
Page 17: Texas Instruments
Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Texas Instruments TUSB1042EVM...