Mira Azora Installation And User Manual page 18

Using your Shower
Read the section "Important Safety Information" first.
1.
Switch on electrical supply.
3.
Set to desired position.
5.
Allow 10 - 15 seconds for any temperature adjustments to reach the handset.
6.
P r e s s S TO P b u t t o n .
Shower will continue to run
for a few seconds before
stopping.
Note! At the end of every shower make sure that the shower head points into the
catchment area. A small amount of water may be retained in the shower handset
after the shower has been turned off. This may drain over a few minutes.
Switch off the appliance at electrical isolating switch when not in use. This is for
safety and is recommended with all electrical appliances.
2.
Press the 'Start/Stop' button.
4.
Check water temperature before
entering shower.
7.
Isolate power.
18
+
_
+
_
8.
Residual water may drain
over a few minutes.