Table of Contents
Advertisement
O
PERATION
Master/Slave
The Master/Slave mode allows a group of Ovation F-55FC products (the slaves) to simultaneously
duplicate the output of another Ovation F-55FC (the master) without a DMX controller.
To set each of the slaves:
1.
Go to the Master/Slave main level.
2.
Select Slave.
To set the master:
1.
Go to the Master/Slave main level.
2.
Select Master.
3.
Select a static setting.
•
The master is the one that runs a program whether in Auto or Static Color mode.
•
Do not connect a DMX controller to the products configured for Master/Slave
operation. The DMX controller may interfere with signals from the master.
•
The master should be the first product in the daisy chain.
Dimmer Profiles
This setting determines how fast the output of the Ovation F-55FC changes when you modify output value.
This setting provides four different options to simulate the dimming curve of an incandescent lighting
product.
•
Go to the Dimmer Mode main level.
•
Select a dimmer curve (Off, Dimmer 1, Dimmer 2, or Dimmer 3).
OFF: The output is proportional (linear) to the dimmer channel values.
Dimmer 1-3: The output follows the dimmer values based on the corresponding
dimmer curve, DIM1 being the fastest.
White Balance
This setting determines the maximum output values for each color, which affects the appearance of a full
output white.
1.
Go to the White Balance main level.
2.
Select Manual to continue to adjust the white balance or Off to default to the original factory
setting.
3.
For Manual mode, select the color value to edit (Red, Green, Blue, Amber, or Lime).
4.
Set the maximum value for the selected color (125–255).
5.
Repeat steps 3 and 4 until the product outputs as desired.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the Ovation F-55FC.
1.
Go to the LED Frequency main level.
2.
Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
Back Light
This setting allows for selection of the amount of time the backlight on the Ovation F-55FC's display stays
on after the last button is pressed on the control panel.
1.
Go to the Back Light main level.
2.
Select Always On (remains on), 10S (10 seconds), 30S (seconds), 2Min (2 minutes).
Factory Reset
This option restores the Ovation F-55FC to factory default settings.
1.
Go to the Reset Factory main level.
2.
Select No or Yes.
Ovation F-55FC User Manual Rev. 2
Page 21 of 24
Advertisement
Table of Contents
