Aqua Lung Conshelf XIV User Manual page 14

14
1. Attach the regulator to a charged SCUBA cylinder and open the cylinder
valve to pressurize the regulator. Thoroughly soak both the first and second
stages in a bath of fresh water for at least one hour to loosen and dissolve salt
and mineral deposits.
WARNING:
as this could damage the diaphragm and the internal valve.
2. After the regulator has been properly soaked, it is important to rinse it vigorously
by flushing the main spring cavity of the first stage regulator (non-environmentally
sealed models only), second stage mouthpiece and the openings in the second
stage front cover with a pressurized stream of water. This will remove the deposits
of salt and minerals that were loosened during soaking.
3. Disconnect the regulator as described in the Post-Dive Inspection section of
this manual and wipe it as dry as possible. Hang it by the first stage to ensure
that all the remaining moisture drains from the second stages and accessories.
4. DO NOT leave the regulator exposed to direct sunlight for prolonged periods
of time.
5. When the regulator is completely dry, store it in a clean equipment box or
sealed inside a plastic bag. Do not store it where it may be exposed to extreme
heat or an electric motor, which produces ozone. Prolonged exposure to extreme
heat, ozone, chlorine and ultraviolet rays can cause premature degradation of
the rubber parts and components.
6. When transporting your regulator, take the necessary precautions to ensure
that it is surrounded by a protective cushion to prevent undue shock or impact.
7. Never store the regulator while it is still connected to the cylinder valve.
If you use a garden hose, DO NOT use the high pressure jet
Conshelf XIV User's Manual