To Service A Gas Valve; To Remove The Solenoid - Fisher & Paykel CG913T Service Manual

599266B

6.8 To service a gas valve

1. Remove the hob top and tray.
2. Remove the ignition switch loom.
3. Remove the screws on the body of the gas valve.
4. Gently lift out the valve cone and clean with solvent.
5. Regrease the cone with high temperature grease.
6. Refit and rotate the cone.
7. Lift out the cone, remove any excess grease and check the holes in the cone and the valve
body are not blocked.
8. Reassemble the valve assembly.
9. Open and close the valve several times.
10. Check the valve for leaks and reassemble the cooktop in reverse order.

6.9 To remove the solenoid

1. Remove the manifold. (refer Section 6.7)
2. Remove the screws from the side of the manifold bracket securing the solenoid.
3. Separate the solenoid from the manifold.
Note: Check the o-ring in the replacement solenoid has a light layer of grease. Take care not
to pinch the o-ring when reinserting the manifold.
Check for leaks.
14