Maxcom MM920 User Manual page 14

3. Plug the charger cable into a slot at the top edge of
the phone. A message about the charger being
connected will appear on the display screen, and
the battery icon will keep blinking while the phone is
being charged.
4. When the battery is fully charged, unplug the
charger from the power outlet, and then unplug the
cable from the phone. Put the cover over the
USB/headphones port in position.
As soon as the charging process is completed, the
message "Charging Completed" will appear on the
display screen, and the battery icon will stop
blinking.
Important:
Before you start the charging process, make sure
o
the battery is properly installed.
Never remove the battery while charging – doing
o
so might damage the phone.
If the battery level is too low to work properly,
o
there will be the message on the screen telling you
that the phone is about to be automatically
switched off, and the phone will automatically
switch off.
If the battery is fully discharged (because for
o
example you had left the torch on), it might be
necessary to wait several minutes for the battery
icon to appear after the battery is plugged in.
14