Honeywell RMA801 User Manual page 31

Input Calibration
Low Point
[CAL Lo ] Input Calibration Low Point
Input Calibration
High Point
Input Calibration High Point
[CAL Hi]
Pressure Units:
inH2O@39° F
mH2O@4° C
cmH2O@4° C
torr
mmH2O@68° F
ftH2O@68° F
inH2O@68° F
inH2O@60° F
torr, atm
Pa, kPa, MPa
Pressure/ gf/cm2, kgf/cm2
Temperature psi
Base Units mbar, bar
[B UNIT] inHg@0° C
mmHg@0° C
mmH2O@4° C
Temperature Units:
° C
° F
° R
NOTE:
BUNIT should not be changed for STT700 DE device & STT250 DE device in both digital and
analog mode
Revision 2
K
mV
Ohm
RMA803 Remote Indicator User's Guide
This selection allows the user to
perfom calibration for 4 mA.
Note: You must connect a current
meter to the transmitter to monitor
the loop output. And the
device/loop current need to set to
exact 4mA.
This selection allows the user to
perform calibration for 20mA.
Note: You must connect a current
meter to the transmitter to monitor
the loop output. And the
device/loop current need to set to
exact 20mA.
Choose appropriate engineering
Base Unit of transmitter units from
list as per Pressure or Temperature
PV selection.
Press ↵ to
enter menu
selection
↓ Menu to
select
number.
↵ to enter
and shift to
the next digit
to the right
Press ↵ to
enter Menu
selection
Menu to
select level.
↵ to Enter
20