Table 5: Rma801: Standard Display Menu - Honeywell RMA801 User Manual

Parameter Parameter Values
Pressure (PRESURE)
Temperature (TEMP)
PV Display
[SEL PV]
Loop Output (LOOPOUT)
Percent Output (% OUT)
Pressure Units:
Pressure/
Temperature
Units [ UNIT]
Temperature Units:
Enter LRV
[ENTLRV]
#. ##
#. ##
Enter URV
[ENTURV]
NOTE:
ENTLRV & ENTURV should not be changed for STT700 DE device & STT250 DE device in both
digital and analog mode
19

Table 5: RMA801: Standard Display Menu

inH2O@39° F
mH2O@4° C
cmH2O@4° C
torr mmH2O@68° F
ftH2O@68° F
inH2O@68° F
inH2O@60° F
atm
Pa, kPa, MPa
gf/cm2, kgf/cm2
psi
mbar, bar
inHg@0° C
mmHg@0° C
mmH2O@4° C
° C
° F
° R
K
mV
Ohm
RMA803 Remote Indicator User's Guide
Desription
Use the selection when RMA is
connected to Pressure transmitter
Use the selection when RMA is
connected to Temperature
transmitter
use the selection to show mA loop
current value in the RMA.
Use this selection to show %age
equivalent of mA loop current.
Choose appropriate engineering
units from list as per Pressure or
Temperature PV selection.
The limits are:
-999999 to 999999
The LRV/URV value will be
available in Pressure/Temperature
Units (Standard Display Pressure/
Temperature unit)
Menu
Operation
Press ↵ to
enter menu
selection
↓Menu to
select from
list
↵ to enter
Press ↵ to
enter Menu
selection
Menu to
select level.
↵ to Enter
Press ↵ to
enter menu
selection
↓ Menu to
select
number.
↵ to enter
and shift to
the next digit
to the right
Revision 2