Table of Contents
Advertisement
P
P
A
IONEER
ATIO
WNING
I
NSTALLATION
6"
(approx.)
Upper
Bracket
Bottom
Bracket
I
NSTALLING AN AWNING RAIL
1.
Position the awning rail along the roof line (line where roof and wall meet) or a minimum of 6" above
the upper edge of the door or windows the awning is covering. Awning rail must be level and parallel
with the floor line of the vehicle.
2.
After determining mounting position, mark the position with a chalk line.
3.
Seal the back of the rail with silicone sealant or putty tape.
4.
Align the awning rail onto the wall and secure with #10 x 3/4" screws. Use
all the attachment holes in the rail.
5.
Use a screwdriver to spread open the left end of the awning rail on the
installation side.
6.
File any sharp edges or burrs from the end of the rail. This will help protect
the awning fabric from damage during installation.
7.
Spray inside the awning rail track with silicone lubricant.
A
SSEMBLING THE
1. On a flat surface, layout the arms and roller tube
assembly. Note: Position the roller tube with the
fabric oriented as shown, over the top with the
polyrod toward the vehicle.
2. Slide the idler end plug (LH arm) onto the roller
tube. Align the fabric access slot in the cap with the
roller tube slot w/ the polyrod. Attach the cap to the
roller tube using three (3) #10 x 5/8 square drive
truss head screws.
3. Repeat for the RH arm.
2
Installation Manual
5"
Awning Rail
o
90
typ
Floor Line
(
IF REQUIRED
A
WNING
Awning Width
Fabric Width
(approx.)
6"
minimum
(Door to Awning
Rail Clearance)
)
Align the Cap Access Slot and
Roller Slot w/ the Polyrod
Carefree of Colorado
5"
(approx.)
Manual Crank
Arm Latch Lever
mc001
#10 x 5/8 Square Drive Screw
(3 per end cap)
Orient Roller Tube with Fabric
Winding Over the Top
Spread open
the end of the
awning rail
SF030
PL003
0052561-001r5
Advertisement
Table of Contents
