Microtek ObjectScan 1600 User Manual page 14

NOTE: If you have to transport the scanner, you will need to lock the scanner
back. Follow the steps below:
1. Turn off the scanner if your scanner is on. Make sure that the power button
2. Turn the scanner back on. Make sure that the Hi-Speed USB cable has
3. Using a flat-head screwdriver, pass through a round circle at the outer shell
4. Shut down ScanWizard Graph software program and turn off your scanner.
14 ObjectScan 1600 User's Manual
light (green power light) is off.
connected computer with your scanner properly. Then, activate ScanWizard
Graph software program. Make sure that the control panel of the software
has been displayed on the screen successfully.
of the scanner and insert a hollow side of the locking screw. Push down
with force and turn the locking screw clockwise 90 degrees to the lock
position.
Hereby, the scanner is ready for transport.