Position Materials - Microtek ObjectScan 1600 Quick Start Manual

Position Materials

A. Locate a handle at the front panel of the scanner. Grab it to pull out the drawer
of the scanner until reaching the edge of end.
B. If the height of a scanned object is less than 2.76" (7 cm), center the object to
be scanned facing up directly on the upper scan bed.
When placing the scanned object, do not block the calibration area.
Upper scan bed
The calibration area (white strip) is next to the
upper scan bed which is an independent and
unremovable entity located at the right side of the
drawer.
To ensure optimal image quality during scanning,
remove the protective film from the surface of the
calibartion area before using the scanner.
During placement of the object,
make sure that the calibration area
is kept clear and free of obstruction
at all times.
5