3
4
5
1. Backplane 2. Mounting panel 3. Omni antenna 4. Antenna kit 5. W140A
Fig. 2.3-2 The Necessary Components in the Wall-Mounted Mode
To install the W140A in the wall-mounted mode, follow the steps below:
1.
Installing the mounting panel: Drill four holes (8 mm in diameter) in the wall
with an impact drill. Clear the dusts and mount the expansion screws, making
the four holes in a rectangular (measuring 230 mm horizontally by 352 mm
vertically) perpendicular to the ground. Fasten the mounting panel to the wall
using the expansion screw kit.
2.
Installing the backplane: There are four fastening holes in the backplane of the
W140A, as shown in Fig. 2.3-3. Fix the backplane to the wall using four
matched screws.
Chapter Error! Style not defined. Error! Style not defined.
1
2
2-13