Installing Antenna - Zte ZXR10 Instruction Manual

●
●
●
3.
4.
5.
6.
7.

2.3.3 Installing Antenna

The omni antenna of the W140A can be installed directly on a wall or a pole. It gets
connected to the antenna arms which is installed in the W140A backplane.
Chapter Error! Style not defined. Error! Style not defined.
antenna to the antenna stand using a U-shape clamp.
Note:
All the antennas must be clamped on the metallic casings, to ensure that all the
other parts in the antennas do not bear any weight.
The antenna feeder shall go through the left and right locks of the W140A to make
it look nicer.
The omni antenna should be secured to the pole.
Installing the mounting panel: Secure the mounting panel to the installing
support by using a fixture.
Installing the backplane: There are four fastening holes in the backplane of the
W140A, as shown in Fig. 2.3-3. Fix the backplane to the wall using four
matched screws.
Installing the W140A: Securing the W140A with a backplane to the mounting
plane on the wall with reference to the three fastening holes in the backplane and
by using the fastening screws.
Fixing the antenna: Turn the antenna stand to place the antenna in an optimum
position. Then tighten the U-shape fixture to fix the antenna stand firmly.
Connecting the cable: Interconnect the U-interface cable led out from the
distribution box with the twisted pairs of the W140A, and carry out water-proof
and anti-aging treatment. Connect and tighten the cable connectors of the
antenna with the antenna interface of the W140A, and make sure that they are
waterproof.
2-21