Rand McNally TND 760 Fleet Edition User Manual page 4

FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
FCC WARNING
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Exposure to Radio Frequency Radiation.
The TND 760 device transmits and receives radio frequency (RF) energy
through its internal antennas. The TND 760 cellular antenna is located
at the top of the left edge of the device. The Wi-Fi antenna is located
near the center of the bottom edge of the device. The TND 760 is
designed to operate with internal antennas and has no provisions
for external antennas.
The TND 760 has been designed, tested and manufactured to comply
with the limits for exposure to RF energy set by the FCC. The radiated
output power of the TND 760 device is below the FCC radio frequency
exposure limits. The FCC has granted an Equipment Authorization for this
model device with all reported SAR levels evaluated as in compliance
with the FCC RF exposure guidelines. SAR information on this model
device is on file with the FCC and can be found under the Display
Grant section of http://www.fcc.gov/oet/fccid after searching on
FCC ID: A4C 01001A
FCC Caution
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
this equipment.