Onstate And Save - SMS ControlMate User Manual

When any function or output is triggered by a command, the pulse and other settings are observed
as always.

ONSTATE and SAVE

Provide the means to initialise the controller outputs to a 'known' state, or restore the last used
output states.
ONSTate sets the initial value that is required after the
next power-cycle or restart.
These will be used if SAVe mode is turned OFF, but if
SAVe is turned ON, the controller will immediately store
the 'current' output states, and automatically keep them
updated with any changes – so that if a power failure
occurs, the relays will be restored to the current states
upon restarting.
IMPORTANT: SET SAV OFF
– until they are explicitly defined using
SMS ControlMate/3G © 2016-2018
will revert to using the most recent states
SET ONST n ON/OFF
info@SL4P.net
>set onst 2 on
Initial state for Output 2
ON (Out 2 ON)
>set last on
Use Last-Known out state
>set last off
Use saved out states
as required.
Page 34 of 56