General Operating Instructions - Harbor Freight Tools Central Pneumatic 97728 Set Up And Operating Instructions Manual

but the output will not exceed the
tool's maximum air pressure at any
time. Adjust the pressure gradually,
while checking the air output gauge
until the required pressure valve is
indicated on the gauge.
8. Inspect the air connections for leaks.
Repair any leaks found.
9. If the tool will not be used at this
time, turn off and detach the air
supply, safely discharge any
residual air pressure, and release
the throttle and/or turn the switch to
its off position to prevent accidental
operation.
note: Residual air pressure should not be
present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion
after disconnecting to ensure that the
tool is disconnected and unpowered.
OpERATIng InSTRUcTIOnS
Read the EnTIRE IMpORTAnT
SAFETY InFORMATIOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Inspect tool before use, looking
for damaged, loose, and
missing parts. If any problems
are found, do not use tool until
repaired.
Work piece and Work Area Set Up
1. Designate a work area that is clean
and well-lit. The work area must not
SKU 97728 For technical questions, please call 1-800-444-3353.
allow access by children or pets to
prevent injury and distraction.
2. Route the air hose along a safe
route to reach the work area without
creating a tripping hazard or exposing
the air hose to possible damage.
The air hose must be long enough
to reach the work area with enough
extra length to allow free movement
while working.
3. Secure loose workpieces using a vise
or clamps (not included) to prevent
movement while working.
4. There must not be hazardous objects
(such as utility lines or foreign
objects) nearby that will present a
hazard while working.

general Operating Instructions

1. If an automatic oiler is not used,
a few drops of Pneumatic Tool Oil into
the Quick Connector before use. Add
a few drops daily.
2. Once the Router Bit (not included)
has been installed, depth of the cut
should be adjusted. To do so, grasp
the Housing Cap (30) and Lock Nut
(31) and turn in opposite directions.
Rotating the Router Base (32) in a
clockwise direction will decrease
the cut depth, and when turned in a
counterclockwise direction, depth of
cut would increase. (See Figure A.)
3. Attach an air hose to the Air Router.
Then turn on the air compressor and
set its regulator at no more than 90
pSI. never exceed 90 pSI for this
tool.
4. For ease of gliding, both work piece
surface and face of the Router Base
add
Page 9