Table of Contents
Advertisement
read the ENTirE imPOrTaNT saFETY iNFOrmaTiON section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
air Outlet, connect
hose to Hammer
7.
The Frame (24) should be positioned so that the mounted Mini Planishing Ham-
mer is extending slightly over the edge of the workbench. This will help to accom-
modate various shapes being plannished.
8.
Screw off the Coil Spring (15) and remove the Anvil Head (21) and Hammer
Shank (23) from the Cylinder (14).
9.
Slide the Hammer Body (1) into the Frame (24).
10.
Insert the Anvil Head (21) into the Anvil Shaft (19) and tighten in place with Hex
Screw (20).
11.
Place the Anvil Head (21) and Hammer Shank (23) into the Coil Spring (15) and
screw onto the Cylinder (14). see Parts list and assembly diagram on page
11 and 12.
SKU 97028
For technical questions, please call 1-800-444-3353.
Figure 3
OPEraTiNg iNsTruCTiONs
air inlet, connect hose
to air compressor
REV 08a
Page 8
Advertisement
Table of Contents
