Flushing And Checking For Leaks - Kraus Artec Pro KPF-1603 Installation Manual

Step 5: Flushing and checking for leaks
1
2
7
Pull the hose assembly out of the spout
and remove the spray head by
unscrewing it from the hose in a
counterclockwise direction. Be sure to
hold the end of the hose down into the
sink and turn the faucet on to the warm
position where it mixes hot and cold
water.
Flush the water lines for one minute. This
ushes away any debris that could cause
damage to internal parts. Check for leaks.
Reinstall the spray head by hand
tightening it back onto the spray hose.
NOTE:
1.Do not lose the rubber washer (1) when
installing back the sprayer
2.The magnet end marking with black dot
should be toward the hose for correct
magnet installation
217
8 17/32"
10
9
1
Cold Wat
1
1