Rl Playback From The Middle Of A Phrase; St Halting Playback/Recording - Roland AR-3000SD Command Reference Manual

RL Playback from the Middle of a Phrase
Function: Playback from the Middle of a Phrase
Syntax:
stxRL:a,b;
Syntax:
RL:a,b
a: Locate Forward / Backward
0 Backward
1 Forward
b: Offset Time
0H0M0S0F – 11H59M59S**F
Example)
RL:1,0H10M59S0F
- After specifying a phrase: Playback begins 10 minutes 59 seconds from the beginning of
the phrase of the specified number.
- While playback is paused: Playback begins from the point that is 10 minutes 59 seconds
after the point where the pause was initiated.
Note: The number of digits for **F (frame) increases according to the value of MTC type.
The range in which the offset time can be specified is valid only within a single phrase.
An offset time that exceeds the recording time for the phrase cannot be specified.
(The AR-3000SD outputs an ER command.) You can play back a phrase from a point
offset by a specified time before or after a paused point by sending this command while
playback is paused (see the PE command).
* When "Return Specified" is issued with an offset time longer than elapsed time:
The phrase is played back from the beginning.
* When "Forward Specified" is issued with an offset time longer than the remaining time:
An ER command is output and playback is not carried out. (The paused state remains in
effect, so specify a new offset time and send an RL command again.)
Caution: The command is not compatible with the Dual Mono.
Phrases other than audio phrases cannot be specified.
The command is not compatible with audio phrases recorded in Mode 2.
ST Halting Playback/Recording
Function: Halting playback/recording
Syntax:
stxST;
Syntax:
ST
(RS-232C, Command format: Type 2)
(Telnet, Command format: Type 2)
(RS-232C, Command format: Type 1)
(Telnet, Command format: Type 1)
AR-3000SD (Ver.1.00) Command Reference - 36