Table of Contents
Advertisement
= RL
Playback from the Middle of a Phrase
Function:
Playback from the Middle of a Phrase
Syntax:
stxRL:a,b;
a: Locate Forward / Backward
0 Backward
1 Forward
b: Offset Time
0H0M0S0F – 11H59M59S**F
Example)
stxRL:1,0H10M59S0F;
- After specifying a phrase:
Playback begins 10 minutes 59 seconds from the beginning of the phrase of the
specified number.
- While playback is paused:
Playback begins from the point that is 10 minutes 59 seconds after the point where
the pause was initiated.
Note:
The number of digits for **F (frame) increases according to the value of MTC type.
The range in which the offset time can be specified is valid only within a single phrase.
An offset time that exceeds the recording time for the phrase cannot be specified.
(The AR-3000R outputs an ER command.) You can play back a phrase from a point offset by
a specified time before or after a paused point by sending this command while playback is
paused (see the PE command).
* When "Return Specified" is issued with an offset time longer than elapsed time: The
phrase is played back from the beginning.
* When "Forward Specified" is issued with an offset time longer than the remaining time:
An ER command is output and playback is not carried out. (The paused state remains in
effect, so specify a new offset time and send an RL command again.)
Caution:
The command is not compatible with the Dual Mono.
Phrases other than audio phrases cannot be specified.
The command is not compatible with audio phrases recorded in Mode 2.
= ST
Halting Playback/Recording
Function:
Halting playback/recording
Syntax:
stxST;
= PE
Pause and Restart Playback or Recording
Function:
Pause and Restart Playback or Recording
Syntax:
stxPE;
Note:
When this command is sent during phrase playback/recording, the AR-3000R stops
playback/recording and enters the paused state. Sending the PE command again releases
the pause, and playback/recording resumes from where it was paused. When operation is
paused with the PE command, the AR-3000R outputs the elapsed time from the start of the
phrase to the point where paused. (Refer to AE command 4. 4. 1)
Caution:
The command is not compatible with the Dual Mono.
Phrases other than audio phrases cannot be specified.
The AR-3000R cannot respond to this command during crossfades, repeats or
intervals.
The command is not compatible with audio phrases recorded in Mode 2.
(AR-3000R will transmit an ER command.)
* The Pause/Restart Recording function was added from the AR-3000R system version 2.01.
R Ver.2.01 R
AR-3000
S-232C Reference - 15
Advertisement
Table of Contents
