Clock And Timers - Panasonic SC-HC200 Operating Instructions Manual

█ Selecting a preset station
1
Press [PLAY MENU] repeatedly to select
"TUNE MODE".
2
Press [R, T] to select "PRESET" and then press
[OK].
3
Press [2/3] or [5/6] to select the preset
station.
Improving the sound quality
When "FM" is selected
1
Press [PLAY MENU] repeatedly to select
"FM MODE".
2
Press [R, T] to select "MONO" and then press
[OK].
To cancel, select "STEREO".
"MONO" is also cancelled when you change the
frequency.
To memorise the setting
Continue with step 4 of "Manual presetting". (
Checking the signal status
When "FM" is selected
Press [DISPLAY].
FM - - - - The FM signal is in monaural.
The system is not tuned in to a station.
FM ST The FM signal is in stereo.
FM MONO "MONO" is selected as the "FM MODE".
AM allocation setting
For Australia and New Zealand
This system can also receive AM broadcasts allocated in
10 kHz steps.
1
Press [RADIO] to select "AM".
2
Press and hold [8] on the main unit.
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
• To go back to the initial setting, do the above steps
again.
• Preset frequencies are erased after you change the
setting.

Clock and timers

Setting the clock
This is a 24-hour clock.
1
Press [SETUP] repeatedly to select "CLOCK".
2
Press [R, T] to set the time and then press [OK].
To check the time
Press [SETUP] repeatedly to select "CLOCK" and
then press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Sleep timer
The sleep timer switches off the system after the set time.
1
Press [SETUP] repeatedly to select "SLEEP".
8)
2
Press [R, T] to select the setting (in minutes) and
then press [OK].
To cancel, select "OFF".
Note:
•
The remaining time is shown at every minute except when
other operations are being performed.
"SLEEP 1" will always be shown when only 1 minute
remains.
•
The sleep timer always comes first. Be sure not to set an
overlap of timers.
Play timer
You can set the timer to come on at a certain time to wake
you up.
Preparation
Set the clock.
1
Press [SETUP] repeatedly to select "TIMER ADJ".
2
Press [R, T] to set the start time and then press
[OK].
3
Repeat step 2 to set the end time.
4
Press [R, T] to select the music source you want
to play and then press [OK].
To start the timer
1
Press [SETUP] repeatedly to select "TIMER SET".
2
Press [R, T] to select "SET" and then press [OK].
"#" is shown.
To cancel, select "OFF".
The system must be switched off for the timer to
operate.
9