Connections; Control Layout; Basic On-Screen Display Setup - Vimar 46910.H10A Installation And Operation Manual

1. Connections

Rear Interface
DC HDMI VGA AUDIO IN VIDEO IN VIDEO OUT
DC: Only use the 12V DC power supply included with the monitor.
HDMI: (High-Definition Multimedia Interface) Supports digital video and audio connections.
VGA: 15 pin D-sub cable for standard VGA connection.
Audio IN: 3.5 mm stereo jack connection for audio input when using VGA /AV connector.
VIDEO/AV IN: BNC connections supporting composite video inputs from equipment such as Cameras or DVR's.
VIDEO/AV OUT: Composite video loop though output – connect a second monitor.

2. Control layout

Source Menu - + Power
Source: Selects input mode – AV,HDMI , VGA.
Menu: Access to the On Screen Display (OSD) menu.
+ and -: Volume controls up/down, confirm input source selecton and navigation in the OSD.
Power: Turns the monitor on or off.

3. Basic on-screen display setup

1- To access the OSD Menu press 'MENU'.
2- Use the '+' or '-' buttons to select the required menu item, then press the 'SOURCE' button to select the Sub menu.
3- Continue to use the 'SOURCE' button to highlight the required field, then press '+' or '-'' to adjust the setting.
4- Press the 'MENU' button to return to previous menu.
5- Press the 'MENU' button again to exit the OSD Menu completely.
6- N.B. To Lock or Unlock OSD settings after set up. Press and hold "menu" button for 5 seconds.
The layout of the OSD will change depending on the input that is selected
6
EN