Hach H160 User Manual page 6

1. Disconnect the equipment from its power source to verify that it is or is not the source of the
interference.
2. If the equipment is connected to the same outlet as the device experiencing interference, connect
the equipment to a different outlet.
3. Move the equipment away from the device receiving the interference.
4. Reposition the receiving antenna for the device receiving the interference.
5. Try combinations of the above.
Product overview
Always disconnect power to the meter before an electrode is changed. Only use the meter as instructed in this
manual or instrument damage can occur.
The meter is available in two models:
• H160—pH and ORP
• H170—pH, ORP, conductivity, TDS and salinity
The H-series waterproof handheld meters use glass sensor electrodes with BNC connectors and
non-glass probes with ISFET (ion sensitive field effect transistor) silicon chip sensors. The meters
use one pH electrode (a BNC pH electrode or an ISFET pH probe) at a time. When a meter is set to
on, the meter automatically identifies the type of electrode that is attached.
Figure 1 Handheld meter
1 Rubber dust caps
2 Conductivity probe connection (12-pin, H170 only)
3 BNC probe connector
4 3.5 mm phono jack for glass pH electrode, ISE,
ORP or DO temperature sensors
Product components
Make sure that all components have been received. Refer to
damaged, contact the manufacturer or a sales representative immediately.
6 English
N O T I C E
5 ISFET pH probe connector (8-pin)
6 LCD display
7 Power button
8 Battery cover
Figure 2. If any items are missing or