During Use; After Use - Amprobe GP-2 GeoTest Instruction Manual

F Use the instrument in TT, TN, IT system and industrial, civil, medical electrical plants,
in normal conditions (contact voltage limit 25V) and in particular condition (contact
voltage limit 50V).
F
Do not take measurements on circuits exceeding the specified current and voltage
limits.
F
Do not take measurements under conditions exceeding the limits stated in paragraphs
9.2.1 and 9.2.2.
F
Make sure that the batteries are properly installed.
F
BEFORE connecting the alligator clips to the circuit under test, make sure that the
switch is in the correct position.
F
Make sure that the display shows the same function as that to which the switch is set.
1.2.

DURING USE

Please read carefully:
WARNING:
F
Before setting, or changing, the switch position, disconnect the alligator clips from the
circuit under test.
F
When the instrument is connected to the circuit under test, do not touch any unused
terminal(s).
F
Do not take resistance measurements in the presence of external voltages; even if the
instrument is protected, any excessive voltage may cause unit malfunction.
WARNING:
1.3.

AFTER USE

F
After use, move the switch to the OFF position.
F
If you do not expect to use the instrument for more than 30 days, remove the batteries.
Should you fail to keep to the prescribed instructions you could
damage the instrument and/or its components or endanger your
personal safety.
If, during use, the symbol
replace the batteries (see paragraph 8.2). The instrument is
able to keep in memory any previously saved data for
approximately 10 minutes.
EN - 4
GP-2 GeoTest
appears, suspend the test and