FASTENER TORQUE SPECIFICATIONS
These torque charts are to be used with the specific "M" Series processor parts
manual for the unit being repaired.
All fasteners will be used with lube or medium strength thread adhesive. Bolts must
have their threads wire brushed or cleaned with a thread die, then cleaned with solvent
and finally, cleaned with compressed air. Threaded holes must be cleaned with a
thread tap, solvent, and also with compressed air.
Use a common chassis or wheel bearing grease on fasteners listed as lubed. Grease
the threads of the bolt and the contact surface under the bolt head. Grease the contact
surface of nuts.
Use a few drops of medium strength thread adhesive on the threads of fasteners listed
as torqued with adhesive.
Do not use anti-seize compound on any fasteners, unless otherwise noted.
-
-
122