JAW SET INTERCHANGE
TOOL AND SUPPLIES
The following are tools and supplies needed to properly change jaw sets.
At least one lifting device, such as a crane or lift truck with adequate capacity for the
particular model being worked on.
A supporting device, such as a second crane or lift truck.
Lifting and securing straps or chains with adequate capacity for the model being
worked on.
Three wood blocks, 4" x 4" (100 x 100 mm) or larger.
14 mm hex key socket (available as NPK part no. M380-1000).
14 mm hex key wrench.
1/2" drive breaker bar.
3/4" or 1/2" air gun (if available).
Brass drift pin.
Dead blow hammer or non-metallic rod or hammer (such as nylon or wood).
Ball peen hammer.
Sledge hammer.
NPK assembly tube, p/n 35027310 for the M20 and 35027200 for the M28 and M38
models.
Spanner wrench.
Qty. 2 - #20 JIC steel caps.
If removed jaw set is to be stored, it is recommended to:
Grease.
Set on a wood pallet.
Use a protective tarp for outside storage.
-
-
110