JAW SET INTERCHANGE
ATTACHMENT OF JAW SET TO THE MAIN FRAME
6. Using a hex key socket (t42), install
the socket head cap screw (OO)
securing the pivot pin nut (c32). See
the "FASTENER TORQUE CHART"
section of this manual for the correct
torque.
ATTACHMENT OF THE JAWS TO THE CYLINDER SUB-
ASSEMBLIES
7. Begin with either of the cylinder jaw pins. Align the bore on the jaw with the bore
on the cylinder.
8. Insert the cylinder jaw pin (c9) into the bore.
EARLY UNITS
9. Early units: Install the cylinder pin lock plate (c30).
Later units: Install the cylinder pin lock plate (c31). NOTE: Left hand thread
(c57).
EARLY UNITS
LATER UNITS
LATER UNITS
-
-
120