Setting Your Temperatures - Smart temp Falcon SMT-880 User's And Installer's Manual

In cooling only mode, your Falcon will control your AC system to cool your home or office. It will not heat
your home or office regardless of low your home or office temperature becomes.
Auto Mode
In Auto mode, your Falcon will decide whether to activate your heating and cooling system to maintain
your home or office to your preferred comfort level. This mode is recommended, particularly if you have
the optional zoning module fitted.
Fan Auto
Fan Auto mode will intelligently control your AC fan in the best way to maintain your desired home
comfort levels. It is highly recommended you leave your fan in Auto Fan Mode. The Fan will turn on when
needed and off again automatically when not needed.
Fan Continuous
If you select continuous fan, the AC fan will not stop but continue to run endlessly provided the Falcon is
NOT supplying warm or cooled air to satisfy comfort levels. This can be good to improve the "stuffiness"
of your home or office but may conflict with any zone control settings you may have.
Fan Speed (If Fitted)
You are able to manually select a fan speed or, let the Falcon choose the most appropriate fan speed for
you. It is highly recommended that you leave this setting in Auto speed.

Setting your Temperatures

Tapping
Program
open the
programming window
here. In this window you
set your comfort levels as
make other adjustments
below.
Temperature
This large display in the
this window displays the current temperature and the mode - whether the temperature is Ok or being
heated or cooled.
Heat and Cool set point
Tap the Heat up/down buttons to adjust the current
heat and cool set points to your preferred value. Note,
the heat and cool set point push each other away to
maintain a pre-set spread. At no time will the Falcon permit you to set the heat set point above the cool
set point. The Heat set point will always be lower than the cool set point.
When you adjust your heating or cooling set temperature an option box will open where you can choose
how long the new set temperatures will last (if programming is enabled) or how long you would like the
system to continue to control at these temperatures before automatically shutting down if manual mode
is selected. Simply tap the desired override period within 4 seconds and this will be set. If you fail to make
a section within 4 seconds the Falcon will automatically choose 2 hours by default.
You are given the option to cancel this override at any time should you wish by pressing the "Cancel
Override" button.
the
icon will
shown
are able
well as
as shown
centre of
Page 9