Ver. 1.0 Last Modified 10/26/2009 Introduction The SG-785 is an optional module that is used to improve the communication of RS-485 network. It provides switch selectable pull-high and pull-low resistors on RS-485 network. It also has 15-step switch selectable termination resistor such that the user can select a proper termination resistor to be connected to the RS-485 network easily.
Page 2
SG-785 Pin Assignment LED Display Power LED, Red Termination Resistor LED, Green Switches Termination Resistor Setting Termination Resistance and Pull-high/Pull-low Setting Terminal Block (Y)DATA+, (G)DATA- RS-485 Data Line (R)+Vs, (B)GND Power Line F. G. Frame Ground...
Page 3
SG-785 Switch Setting RS-485 Termination Resistance Setting Termination Resistance (ohm) RS-485 pull-high and pull-low setting SW5 SW6 RS-485 Data Line Status No pull-high/pull-low to RS-485 data line Add a pull high resistor to DATA+ line Add a pull low resistor to DATA- line...