brondell Swash 1000 Owner's Manual page 19

Hide thumbs Also See for Swash 1000:
Table of Contents

Advertisement

OPERATION
Warm Air Dryer Temperature – Swash 1000 Only
While air dryer function is operating, press the Water Pressure/Dry Temp. button "+" and
"-" to adjust warm air dryer temperature to desired level. There are 4 levels for the warm
air dryer: Low – Med – High- Off.
Additional Features
Deodorization – Swash 1000 Only
When you sit down on the seat, the deodorizing function starts automatically on a low
setting. To activate the deodorizer on a high setting, press the Deodorize button on the
remote control. The deodorizing function will run on high for approximately 1 minute.
To stop the function prior to 1 minute, press STOP button at any time.
Nozzle Sterilization – Swash 1000 Only
To sterilize the stainless steel nozzles, press the Sterilize button on the remote control
and a cleansing silver oxide nano particle water treatment begins. The cleansing spray
will last for approximately 30 seconds. To stop the function prior to 30 seconds, press the
STOP button at any time. The silver oxide nano particle treatment system has powerful
anti-fungal and anti-bacterial properties to keep the nozzles clean and corrosion free.
Auxiliary Controls
There are 3 auxiliary buttons on the side of the Swash to be used if remote is unavailable
and to set Swash Special Modes:
1.
Power button – Turns the product On/Off. Press and hold the button for at least 2
seconds to turn off the Swash. Note: if the Power button is pressed while front or rear
cleansing is operating, the cleansing function will stop.
2.
Rear Cleansing – Selects the rear cleansing function.
3.
Nozzle Cleaning – To better clean the nozzles, press this button, the nozzle will extend fully
for easy cleaning. Refer to Maintenance section for additional nozzle cleaning information.
Swash Special Mode Operation
Swash Eco Mode
When Eco Mode is selected: If the Seat Sensor is not activated and no buttons on
Remote have been active for approximately 10 minutes, the seat heater is automatically
set to Low temperature to reduce power consumption. Once Eco Mode is activated, the
Eco Mode light on the seat will turn blue and the other lights will turn off.
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents