Yale SR-310 User Manual page 6

Download the app
•
(08)
Please ensure all devices are powered and operational at this point.
(GB) App download - (IT) Scarica l'App -
(DE) App Download - (NO) Nedlasting av App - (SE) Installera appen -
(DK) Installer APP.
3
(08)
Download the Yale Home App
(GB) App download - (IT) Scarica l'App -
Yale Smart Living Home
(DE) App Download - (NO) Nedlasting av App - (SE) Installera appen -
(DK) Installer APP.
3
Internet Connection: Required on
Yale Smart Living Home
IOS 9.0 +
Android 4.2 +
First time registration
IOS 9.0 +
Follow the set-up instructions in the app.
Android 4.2 +
Serial No.
Serial No.
Please register the hub within one hour of power up, otherwise app 'authentication error' will appear
– re-boot the hub (including switching off / on the back-up battery) and start the process again if
necessary.
Recording your set-up information
E-mail used to set up system:
Smart Security Hub 2.0 serial number
Phone number used for notifications:
Key Pad PIN Code for Disarm/Arm (default
1234):
Key Pad code for key Pad setting (default 0000):
10
iOS 9 +
Android 4.2 +
Please Note:
Serial No.
Panel Serial Number can be
found on the Smart Hub sticker.
Setting up devices
•
Adding new devices
(Optional: Use it only if you have extra devices outside the kit)
All devices in the kit are linked to the Smart Hub. If you want to add more devices, you can do this by using the "Add new device"
section in the Smart Living Home app.
Go to the app menu
Select Add Device, then activate leaning mode.
1
Enter Learn Mode
2
Learn in Devices
Press the learn button on the device you leant to add then see diagrams below. The Smart Hub will beep (single or multiple
dependent on device) when a new device is registered. You will then see your new device in your device List within the home app.
Learn/Test
button
Learn/Test
EF-PETPIR
One single button
One single
press.
press.
Ensure you Learn/Test
button
initialise your
Press 8 and 9
keypad before
together
you learn it in.
(See page 17)
LED
For the following devices, please hold the Learn button for 10 seconds, before releasing to enter Learn mode.
For the following accessories, please hold the Learn button for 10 seconds, before releasing to enter Learn mode.
If the device doesn't learn in, remove the batteries for 5 seconds, then replace and
Learn/Test button
try relearning within 3 minutes.
Hold for 10 seconds
SR-PVC
SR-PC Learn/Test button
Hold for 10 seconds
3
Exit Learn Mode:
Press Stop learning mode on the app
Learn/ Test
Learn/Test
button
button
Press & hold
One single
for 3 seconds
press.
Learn/Test button
One single press.
Learn/Test button
One single press.
SR-PVC must be learned in with the
tamper screw removed so that the tamper
is open. Sensor will not learn with tamper
closed.
Learn/Test button
SR-PS
Hold for 10 seconds
11