Changing Batteries - Yale SR-310 User Manual

Changing Batteries

Always use the correct type of batteries as replacements because any other battery type can cause
problems with the operation of the system. Ensure the correct steps are taken when changing
batteries in tamper protected devices.
Low Battery Indicator
The Hub will start to emit an intermittant beep to indicate that the batteries need changing on one of your
devices.
The hub will continue to beep until the batteries on this device have been replaced, or low battery device is
put into bypass mode. Please note that bypass mode disables the device, and if disabled this device will no
longer be triggered when the alarm is armed.
(GB) Changing batteries - (IT) Sostituzione batterie - (DE) Batteriewechsel - (NO) Batteribytte -
(SE) Batteribyte - (DK) Batteriskift.
The app will also display a low battery message under the relevant device when batteries are running low.
KP
When a device first shows the low battery signal in the app, it has enough capacity to operate for
approximately 1 month before complete exhaustion.
DC
Always make sure the system is disarmed before changing any batteries. We recommend you follow the
battery wizard within the app when changing the batteries.
PC
26
(24)
•
SR-RS
SR-EIR
CHANGE
BATTERY
CR 2032
SR-SR
CR 2032
2 x 1.5v AA
SR-BX
3 x 1.5v AAA
(24)
Changing Batteries
(GB) Changing batteries - (IT) Sostituzione batterie - (DE) Batteriewechsel - (NO) Batteribytte -
(SE) Batteribyte - (DK) Batteriskift.
(GB) Installation - (IT) Installazione - (DE) Installation - (NO) Installasjon - (SE) Installation -
External Siren Battery Change
(DK) Installation.
When the batteries start getting low the Siren will produce a series of audible pips and flashes when arming
and disarming.
1
SR-RS
Note: Take care not to confuse a low battery warning with a tamper warning.
Tamper Warning: Series of beeps when armed, silent when disarmed.
Low Battery: Series of audible pips when armed and disarmed.
SR-EIR
2 x AA
(Lithium 3.6V)
1. Disarm
3
(GB) Reset - (IT) Reset - (DE) Reset - (NO) Tilbakestill - (SE) Återställning - (DK) Nulstil .
SR-SR
t e r y 4.
B a t
f f >
<On Off>
n O
L e a rn
< O
e ry
B a tt ff >
n O
< O
e r
P o w
L A N
Ø 5mm
Switch off
SR-BX
4 x 1.5v D
4
6.
Turn on. Check
the siren beeps &
flashes.
Warning: After the batteries have been inserted, the tamper
will become active after three hours.
(GB) Changing batteries - (IT) Sostituzione batterie - (DE) Batteriewechsel - (NO) Batteribytte -
(SE) Batteribyte - (DK) Batteriskift.
•
3 x 1.5v AAA
3 x 1.5v AAA
2
2 x AA
(Lithium 3.6V)
2.
> Settings
> Devices
> External Siren
> Change battery
4 x 1.5v D
b
a
<On Off>
5.
4 x 1.5v D
Remove old batteries and wait
c
for 30 secs before replacing
with 4 new ones.
4 x 1.5v D
5
7.
b
8. > Done
Replace the cover
SR-EIR
(21)
7
a
b
SR-SR
3.
L e a rn
e ry
B a tt ff >
n O
< O
e r
P o w
d
L A N
SR-BX
6
a
27