Table of Contents
Advertisement
Factory Reset
A factory restart of your station will remove your sensor ID numbers and Wi-Fi settings and return your station
to its default settings and "out of the box" condition. This may resolve connection issues with your sensors or
Wi-Fi.
1. Hold the ALERTS and LIGHT button together for 5 seconds.
2. Your station will reset and search for your sensor.
3. Allow up to 3 minutes to reacquire your sensor.
4. You will need to reconnect to your La Crosse View
app by following the steps on
page 4.
™
Detailed Sensor Set Up and Mounting
LTV-TH2 Thermo-Hygro Sensor
1. Install 2-AA batteries according to polarity and replace battery cover.
Mounting:
1. Use the hole at the top to hang your sensor from the back using a nail. Or, insert one mounting screw through
the front of your sensor.
2. Mount your sensor on a north-facing wall or in any shaded area. Under an eave or deck rail is preferred.
3. The maximum wireless transmission range to the weather station is up to 400 feet (121 meters) in open air,
not including walls or floors.
4. Be sure your sensor is mounted vertically, to allow moisture to drain out properly.
Note: Watch sensor mounting video:
http://bit.ly/TH_SensorMounting
Hole for
mounting
LED Light
TX
F/C
∙ Press TX to send a signal
∙ Press F/C to select Fahrenheit
or Celsius display on sensor.
Battery Cover
Remote Monitoring Color Weather Station
Page | 17
Advertisement
Table of Contents
